"ROLLER CYCLE'S REPAIR & MAINTENANCE PAGE"
WE ARE CURRENTLY IN THE MIDDLE OF CREATING THIS PAGE
AND YOU CAN CHECK IT OUT AS WE WORK
The following maintenance should be done periodically
The spark plug should be carefully cleaned and If necessary discard after 25 running hours and the electrode gap should also be checked (6-7 mm).
After 26 running hours, use gasoline to carefully clean and dry the filter.
After 25 running hours check and tighten up all the screws and nuts.
After 50 running hour remove the muffler from the cylinder and then de-scale the exhaust port of both the muffler and the cylinder, paying attention that no scales get into the cylinder.
After The gearbox on your Roller Cycle, Halle Cycle is virtu-ally maintenance free. Check from time to time to see if any grease is leaking by visually examining the gearbox. At least once every 2 years, disassemble the top lid of your Roller Cycle, Halle Cycle gearbox and remove waste grease. Apply new grease liberally on the sprockets.
The tension on the chain drive should be check prior to operation for slack. Optimum play is 1 cm Use the adjustment brackets on the tire axle to adjust this tension. Be sure to keep
Brake In the event your brake cable becomes loose and gap becomes greater, readjust to set a smaller gap and tighten.
Both throttle and brake cables must be checked prior to each operation. Look for wear, kinks, and proper adjustment (fig. 1 and 2 pp 10-11)
Tires must be routinely checked for proper air pressure and wear. The tire pressure should be between 25 and 30 lbs. depending on the wieght of the rider. Be sure not to inflate the tire unevenly. Fill slowly while centering tire to avoid buldges. Replace tire as tread wears.
The two cycle motor uses a gas and oil mixture at the ration of 32:1 (thirty two to one). This means for every gallon of gas you add 4 ounces of oil. On the cap there is a reminder. It says 32:1.
• If not mixed to proper ratio, the engine performance may decrease, or damage to the engine may occur.
• Use a gauged bottle to measure proper oil mixture.
• For a perfect mix every time, use empty container and add two gallons of new gasoline. Then add a new 8 oz container of kcompletely mixed.
• 1 Gallon add 4 OZ.
webwe
Copyright © 2014 Roller Cycle Inc
site created by jimtdavis